facebook
Free shipping on orders over $49*

Click here for Full Directions

BEFORE YOU BEGIN

  1. Tempaper is recommended for smooth surfaces that are in good condition and have been primed and painted with a satin or semi-gloss finish. Clean surface by wiping with a damp cloth or wet rag, making sure surface is fully dried before application. For an easier install, remove switch plates and outlet covers prior to installation making sure to turn off electricity at source prior to removal.
  2. If applying to a surface that has been painted with a zero VOC paint, wiping surface with a 1:1 Isopropyl alcohol and water solution prior to application may help with adhesion.

SURFACES NOT RECOMMENDED

  1. - Matte, flat, and low sheen paints
  2. - Textured surfaces
  3. - Exterior surfaces

TOOLS

  1. - Craft knife
  2. - Cutting surface
  3. - Level
  4. - Pencil
  5. - Ruler or straight edge
  6. - Step stool
  7. - Squeegee
  8. - Tape measure

APPLICATION (PRE-CUTTING PANELS)

  1. 1. Measure the height and width of your surface, this will determine how many panels you will need.
  2. 2. Pre-cut your first panel to the height of your surface adding 2-3 inches of excess material at the bottom.
  3. 3. Be sure to align pattern with each consecutive panel prior to cutting, numbering the back of each panel as you work.
  4. 4. Using a level, mark a vertical guide down the length of surface.
  5. 5. Peel back 3-4 ft. of the backing.
  6. 6. Begin at the top edge aligning paper with your vertical guide to ensure a straight application.
  7. 7. Use a squeegee to smooth paper to surface working from the center out. Tempaper can be repositioned as needed to ensure pattern alignment and to eliminate bubbling.
  8. 8. Continue in 3-4 foot increments peeling and smoothing until you reach the bottom edge of your surface.
  9. 9. Repeat steps 5-8 until the surface has been fully covered.
  10. 10. Trim where needed with a craft knife to complete your application.

APPLICATION (WORKING FROM THE ROLL)

  1. 1. Using a level, mark a vertical guide down the length of surface.
  2. 2. Place your roll on a soft surface, such as a bath mat or towel, at the bottom edge of starting point.
  3. 3. Pull paper up from roll to meet the top edge of surface.
  4. 4. Peel back 3-4 ft. of the backing.
  5. 5. Begin at the top edge aligning paper with your vertical guide to ensure a straight application.
  6. 6. Use a squeegee to smooth paper to surface working from the center out. Tempaper can be repositioned as needed to ensure pattern alignment and to eliminate bubbling.
  7. 7. Continue in 3-4 foot increments peeling and smoothing until you reach the bottom edge of your surface allowing paper to overhang by 2-3 inches and cut paper from roll.
  8. 8. Repeat steps 2-7 making sure to align pattern with each consecutive panel until the surface has been fully covered.
  9. 9. Trim where needed with a craft knife to complete your application. Helpful Hints If you find the weight of the roll or the backing paper bothersome during application, each section can be carefully cut as you work making sure to leave enough paper to finish application. You may need to move consecutive panels higher than the previous to align pattern. When doing so, cut excess paper from top before you begin application.

REMOVAL

  1. Starting with any corner, firmly peel up or down slowly parallel to the surface. Tempaper has been tested on and successfully removed from various surface types and conditions. LolliProps Inc. may not be held responsible for damaged surfaces or for difficulty of removal. For more information on wall preparation, application, suggested tools and more, please visit the FAQ page.